ⓘ Falsing. In telecommunications, falsing is when a decoder assumes that it is detecting a valid input even though one is not present. This is also known as a fal ..

                                     

ⓘ Falsing

In telecommunications, falsing is when a decoder assumes that it is detecting a valid input even though one is not present. This is also known as a false decode. This article will discuss analog circuits used before digital signal processing.

Examples of decoder falsing include:

  • a ringy telephone circuit with SF single-frequency signaling and poor level discipline drops calls because it sees harmonic frequencies or the distorted waveform as a valid "circuit idle" or "on-hook" SF signal.
  • power line transients cause a telemetry decoder to momentarily decode the power line noise as a false "turn-on" command, causing a remote-controlled water well pump to cycle on and off needlessly.
  • a telephone answering machine detecting dial pulses from a rotary dial as ringing voltage, with the result that the answering machine answers in response to dialing.
  • a two-way radio with an enabled CTCSS decoder turns on the receive audio for one or two syllables of a signal with a close-in-tone-frequency but wrong CTCSS tone. The person listening to the radio occasionally hears nonsense partial words from the receivers speaker: "et". "up".

Analog tone decoders used in telephone and two-way radio systems are designed to work in a balance between expensive, complicated filtering and low cost simplicity. The engineering problem is to make the simplest circuit that will work reliably. A decoder generally tries to filter audio input to strip off every audio component except a sought-after, specific tone. In part, a decoder is a narrow bandpass filter. A signal that gets through the narrow filter is rectified into a DC voltage which is used to switch something on or off.

Falsing sometimes occurs on a voice circuit when a human voice hits the exact pitch to which the tone decoder is tuned, a condition called talk-off.

For the tone decoder to work reliably, the audio input level must be in the linear range of audio stages, undistorted. A 1.500 Hz tone fed into an amplifier that distorts the tone could produce a harmonic at 3.000 Hz, falsely triggering a decoder that is tuned to 3.000 Hz.

                                     

1. Reducing the possibility of falsing

Some systems that use tone signaling require higher reliability and less probability of falsing. One method of reducing falsing uses formats with simultaneous, paired tones. In decoding dual tones such as ICAOs SelCall, Quik Call I, MF, or DTMF, pairs of decoders are used and their outputs are connected to logical and circuitry. When tones are decoded, they are submitted to the and logic. If both are decoded at the same time, the and logic output shows a decoded pair of tones is present. To false in a dual-tone system, both decoders would have to false at the same moment. Two-out-of-five code and similar methods provide an additional check in some applications.

Another method is to subject tone decoding to a time constraint. In the case of Quik Call I or a string of DTMF digits, the falsing would have to occur in the exact order required to actuate the decoder. This is much more improbable than falsing in a single tone decoder. In two-tone sequential, tone and voice radio paging, decoders are actuated by decoding tone and then a second in the proper sequence. Falsing could only occur if the two decoders falsed in a valid sequence within the decoders time constraints. Examples of systems of two-tone sequential paging are Motorola Quik Call II, General Electric Mobile Radio Type 99, and later-model Plectron receivers.

                                     
  • In medical testing, and more generally in binary classification, a false positive is an error in data reporting in which a test result improperly indicates
  • A false dilemma or sometimes called false dichotomy is a type of informal fallacy in which something is falsely claimed to be an either or situation
  • A false accusation is a claim or allegation of wrongdoing that is untrue and or otherwise unsupported by facts. False accusations are also known as groundless
  • In linguistics, false friends are words in different languages that look or sound similar, but differ significantly in meaning. An example is the English
  • False color or pseudo color refers to a group of color rendering methods used to display images in color which were recorded in the visible or non - visible
  • False or falsehood may refer to: False logic Lie or falsehood, a type of deception in the form of an untruthful statement Falsity or falsehood, in law
  • A false flag is a covert operation designed to deceive the deception creates the appearance of a particular party, group, or nation being responsible
  • In religion, a false prophet is one who falsely claims the gift of prophecy or divine inspiration, or to speak for God, or who makes such claims for evil
  • False imprisonment occurs when a person intentionally restricts another person s movement within any area without legal authority, justification or consent
  • A false accusation of rape is the reporting of a rape where no rape has occurred. With regard to the rape allegations made to police or campus authority
  • obtained by false pretenses when the acquisition results from intentional misrepresenting of a past or existing fact. The elements of false pretenses are: